Planet Technology XRT-104D - Manual (Page 54)

49
Sync Flood Protection the router from Sync Flood attack. If
you go to the advanced setting page, you can
configure the threshold of the frequency of
packets occurred.
Click <Save> at the bottom of the screen to save the above configurations and press
“Apply and
Reboot ” to apply the configuration and reboot the XRT-D router. You can now configure other
advance sections or start using the router (with the advance settings in place).
3.5.4 DMZ
If you have a local client PC that cannot run an Internet application (e.g. Games) properly from
behind the NAT firewall, then you can open the client up to unrestricted two-way Internet access
by defining a DMZ Host. The DMZ function allows you to re-direct all packets going to your WAN
port IP address to a particular IP address in your LAN. The difference between the virtual server
and the DMZ function is that the virtual server re-directs a particular service/Internet application
(e.g. FTP, websites) to a particular LAN client/server, whereas DMZ re-directs all packets
(regardless of services) going to your WAN IP address to a particular LAN client/server.
?
Note:
DMZ function works only when the NAT function is enabled.
Parameters Description
Enable DMZ
Enable/disable DMZ
Note: If there is a conflict between the Virtual Server and the
DMZ setting, then Virtual Server function will have priority over
the DMZ function.
WAN Port The WAN port that the local client PC IP will bind to.