Panasonic TZ-PCD2000 - Manual (Page 18)

18
Programming the Remote Control
Programming Without Code
If you cannot find the right Code, you can call up all Codes one after the other to
search for a Code.
1.Turn on the power for the Component to be programmed.
2.Press the mode button (TV, VCR or AUX) for the component to be programmed,
and then press the Setup button and hold for 3 seconds (until the visible LED blinks
twice).
3.Use the numeric buttons on the remote control to enter “991”. After this number is
entered, the LED on the remote control will flash twice.
4.Press the POWER button. (A remote control signal will be transmitted.)
5.If the component turns off, go to step 6. If the component remains on, press the
mode button (TV, VCR or AUX), and then repeat step 4. (Repeat this step until the
right Code is found.)
6.Press the Setup button to register the Code. When programming is complete, the
LED on the remote control will flash twice.
Identifying programmed Codes
If you would like to know what Code has been programmed, you can find out by
observing the flashing pattern of the remote control LED.
1.Press the mode button (TV, VCR or AUX) for the component that you would like to
find out the Code for, and then press the Setup button and hold for 3 seconds (until
the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “990”. After this number is
entered, the LED on the remote control will flash twice.
3.When a “1” is then entered using the numeric buttons, the remote control LED will
flash. The number of times it flashes corresponds to the first digit of the Code. For
example, if the LED flashes five times, the first digit of the Code is 5.
4.When a “2” is then entered using the numeric buttons, the remote control LED will
flash. The number of times it flashes corresponds to the second digit of the Code.
5.When a “3” is then entered using the numeric buttons, the remote control LED will
flash. The number of times it flashes corresponds to the third digit of the Code.
6.When a “4” is then entered using the numeric buttons, the remote control LED will
flash. The number of times it flashes corresponds to the fourth digit of the Code.
7.Write the code numbers for your components in the space provided below. This will
serve as a reference when you need to program your remote control.
AUX button
POWER button
VCR button
LED
TV button
Setup button
Numeric buttons
TV
VCR
AUX
Name of component
TV
VCR , DVD player
( )
( )
( )