Programming the remote control – Panasonic TZ-PCD2000 User Manual

Page 20

Advertising
background image

20

Changing button functions

The functions of the remote control buttons can be assigned to other buttons.

Setting method
(Example) Assigning the function of the POWER button in TV mode to the Exit button
in VCR mode

1.Press the Setup button and hold for 3 seconds (until the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “994”. After this number is

entered, the LED on the remote control will flash twice.

3.Press the TV mode button, and then press the POWER button.
4.Press the VCR button, and then press the Exit button. When programming is com-

plete, the LED on the remote control will flash twice.

Canceling the setting
1.Press the Setup button and hold for 3 seconds (until the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “994”. After this number is

entered, the LED on the remote control will flash twice.

3.Press the Mode button twice. When programming is complete, the LED on the

remote control will flash twice.

Channel lock

The Digital CATV Terminal lets you lock the channel selection (0~9 buttons, CH Up/
Down buttons, Last button) functions. The following procedure can be used to set
whether channel selection is locked or not.

Clearing the lock
1.Press the Setup button and hold for 3 seconds (until the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “973”. After this number is

entered, the LED on the remote control will flash twice.

3.Press the CH - button. When programming is complete, the LED on the remote

control will flash twice.

Setting the lock
1.Press the Setup button and hold for 3 seconds (until the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “973”. After this number is

entered, the LED on the remote control will flash twice.

3.Press the CH + button. When programming is complete, the LED on the remote

control will flash twice.

Reset

You can reset any remote control settings which have been changed.
The settings can be reset in either of two ways.

Operation setting reset
This resets all remote control settings to their factory default values, except for Codes
set in TV, VCR and AUX modes.

1.Press the Setup button and hold for 3 seconds (until the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “980”. When resetting is

complete, the LED on the remote control will flash four times.

Factory default reset
This resets all remote control settings to the factory defaults.

1.Press the Setup button and hold for 3 seconds (until the visible LED blinks twice).
2.Use the numeric buttons on the remote control to enter “977”. When resetting is

complete, the LED on the remote control will flash four times.

Programming the Remote Control

AUX button

POWER button

VCR button

LED

TV button

CH +- button

Numeric buttons

Setup button

Exit
button

Advertising