Polaris D7500 - Manual (Page 14)

14
INSTALLATION
USB Digital Video/Button Control Connection Options - Refer to
corresponding figure below and perform the following procedure to connect the
USB 2 .0 High Speed output of the Polaris Control Module to the associated PC
computer as desired .
1 . Connecting Directly to PC . Connect the supplied 6-foot USB 2 .0 high-
speed cable between the USB connector located on the rear of the Control
Module to be connected and directly to the USB 2 .0 high speed, high power
(500 mA) port on the computer .
2 . Connecting via High Speed Hub . Connect the supplied USB 2 .0 high-
speed cable between the USB connector located on the rear of the
Control Module to be connected and the USB 2 .0 High Speed Hub . If
necessary, connect an additional USB 2 .0 high-speed cable up to 16 feet
long between the High Speed Hub and the USB 2 .0 high speed, high
power (500 mA) port on the computer .
REAR OF USER PC
6-FOOT (2M ) USB 2.0 HIGH
SPEED CABLE (SUPPLIED)
REAR OF POLARIS
CONTROL MODULE
USB 2.0 HIGH SPEED,
HIGH POWER (500mA)
PORT
NOTES:
On PC's that have both front and rear USB 2.0 high
speed ports, it is recommended that the camera
be connected to one of the rear mounted ports for
best results.
Minimum PC processor and operating system
requirements are listed in the Preinstallation
Information of this manual.
A DirectX 9 user-supplied compliant streaming
video capture software application must be installed
on the PC to display live video. The supplied CD
provides the required WDM drivers.
USB Cable Connection Directly to PC
REAR OF POLARIS
CONTROL MODULE
REAR OF USER PC
USB 2.0 HIGH
SPEED HUB
UP TO 16-FOOT (5M) USB 2.0
HIGH SPEED CABLE
6-FOOT (2M ) USB 2.0 HIGH
SPEED CABLE (SUPPLIED) USB 2.0 HIGH SPEED,
HIGH POWER (500mA)
PORT
NOTES:
A hub may be used to connect
the camera to the PC when the
connection is longer than 6 feet or
when the PC only has a single USB
2.0 high speed port and the camera
must be connected along with other
USB devices.
USB Cable Connection via Hub
Use either a self-powered or bus- powered USB 2.0 high speed hub.
Follow installation instructions provided with the hub before connecting the camera.