Porter-Cable 698 - Manual (Page 11)

11
CONNECTING TO POWER SOURCE
CAUTION: Before connecting to power source ALWAYS MAKE
SURE THE SWITCH IS IN THE OFF POSITION and that the power
circuit is the same as that shown on the specification plate of the
Router/Shaper.
1. Plug the motor cord into the short cord extending from the table switch box.
2. Turn the router motor switch ON motor operation will now be
controlled by the switch in the front of the table.
3. With the table switch OFF , connect the long power cord extending from
the table switch box to the power source.
STARTING AND STOPPING
THE MOTO R
CAUTION: Before starting the
motor, make sure work piece and all
foreign objects are clear of bit and
that guards are in place over bit.
TO START MOTOR Move switch
lever (A) Fig. 15 up to the ON position.
T O S T O P M O T O R Move switch
lever (A) Fig. 15 to the OFF position.
SWITCH LOCK
The switch may be locked in the OFF position by
removing the switch key while the switch is in the OFF
position.
To lock switch, place switch in OFF position and pull
switch key out of switch (see Fig. 16). Check to make
sure switch is in OFF position.
C A U T I O N : D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE BEFORE REMOVING SWITCH
KEY TO PREVENT ACCIDENTAL STARTING
WHILE PULLING SWITCH KEY.
Fig. 14
A C
B D
Fig. 15
A
A
Fig. 16