Porter-Cable 698 - Manual (Page 8)

8. Assemble the left hand (out-feed) fence bracket (B) Fig. 9, to the table in
a similiar fashion.
9. Position the wooden fences to the fence brackets (see Fig. 10), and
secure using one, 3 …
8
"-16 x 1 1 …
5
" bolt and matching nut, through each fence
and fence bracket.
FASTENING ROUTER/SHAPER TO WORK BENCH
The Router/Shaper should be securely attached to a firm supporting structure
(such as a work bench) to prevent movement of the machine during use. Two
holes are provided in the bottom flange of each leg for mounting bolts, or the
bottom leg flanges may be clamped to the support with C-clamps.
SELECTING THE BIT
The Router/Shaper will accommodate bits with shanks that are installed
directly into the power unit collet. A table insert with the smallest diameter
hole that will clear the selected bit should always be used.
CAUTION: Do not use router bits larger in diameter than those
recommended for your router (see following chart):
Fig. 10
8
Fig. 8
A
Fig. 9
A B