Planet Technology ENW-9607/9607M - Manual (Page 19)

16
Appendix A Advanced Properties
The default settings of the adapter should work in most cases. However, if you experience any unusual
circumstances during your installation, these settings may help you to trouble shoot the adapter. Do not
change any of these settings without a thorough understanding on your network. The following table
briefly explains the function of each property.
Parameter Description Value
802.1p Support Port A
The IEEE 802.1P signaling method is used for
traffic prioritization at OSI Reference Model
Layer 2. It is implemented in network adapters
and switches for best-effort Quality of Service
(QoS).
Off (default)
On
Log Status Messages
This parameter specifies the messages, which
are to be logged in the Event Log.
All Messages
Errors
None
Status Messages (default)
Warnings
Maximum Frame Size
Specifies the maximum frame size in bytes that
the driver will support. The performance of
your network usually increases when a large
packet size is used. Do not use values larger
than 1514 if you are not sure the network
structure supports jumbo frames.
12-9014
(default: 1514)
Media Type
Specify the link speed of the adapter. For
ENW-9607M, this option is fixed to Autosense.
100Mbps Full Duplex
100Mbps Half Duplex
10Mbps Full Duplex
10Mbps Half Duplex
Autosense (default)
Network Address
Allow the user to configure the network
address of the adapter.
Not Present
Number Of Receive
Buffers
Defines the number of receive buffers
allocated by the driver. If the system does not
have enough resources, the driver will fail to
load. Increasing this value may improve
performance.
3-500
(default: 50)
Number Of Transmission
Buffers
Defines the number of transmit buffers
allocated by the driver. If the system does not
have enough resources, the driver will fail to
load. Increasing this value may improve
performance.
4-500
(default: 50)
Wake Up Capabilities
Specify which method is using to activate the
Wake-On-LAN capability. It is only available
on ENW-9607.
Link Change
Magic Packet
Magic Packet and Pattern
Match (default)
None
OS Controlled
Pattern Match