Planet Technology WL-U356 - Manual (Page 24)

20
u Connect Station List: Display all the MAC addresses of the wireless stations associating
with the AP.
u Current Network Setting: Displays the information about the current wireless network,
including Channel, SSID, WEP and Tx Power Level.
u More Setting: Press this button for further settings including disable/enable WEP, MAC
address Filter and Bridge Adapter, etc. Please refer to the Section 3.7 for detailed
descriptions of each item.
u Tx and Rx Frame: Shows the number of valid transmitted/received data frames of the AP.
3.7 Access Point Setting
You can enter this screen by clicking the “More Setting…” button. Here you can configure the AP
connection settings such as Channel, Basic Rate, SSID, Tx Power, WEP, Authentication Mode
and other advanced functions.
u General Connection Setting: Displays the connection information of the AP, including
Channel, Basic Rate, SSID and Tx Power. You can click the “Change” button to modify
these values.
Ø Channel: Selects the number of the radio channel used by the AP.
Ø Basic Rate: Selects the basic data transmission rate supported by the AP. There
are four options, including “1, 2Mbps (Mixed mode)”, “1, 2, 5.5, 11Mbps (Mixed),” 1,
2, 5.5, 11, 6, 12, 24Mbps (802.11g), and “6, 12, 24Mbps (802.11g only).” If the AP