Paradyne Hotwire 5038-A1-00 - Manual (Page 4)

4
Installing the POTS Splitter With an RTU
The POTS splitter connected to the RTU uses three cables with RJ11 connectors.
The three cables are installed:
H
From the Local Loop to the POTS splitter (supplied cable)
H
From the POTS splitter to the telephone (existing cable)
H
From the POTS splitter to the RADSL RTU (cable supplied with the RTU)
"
Procedure
To connect a POTS splitter to a phone and an RTU:
1. Unplug the existing cable from the local loop.
2. Plug the existing cable into the POTS splitter jack labeled PHONE.
3. Plug the end of the cable supplied with the RTU into the POTS splitter jack labeled
DSL. Plug the other end into the RTU jack labeled DSL.
4. Plug the end of the cable supplied with the POTS splitter into the POTS splitter jack
labeled LINE. Plug the other end into the line from the local loop.
98-15812
POTS Splitter
Line from
Local Loop
(Supplied Cable)
DSL
Hotwire RTU
LINE
DSL
PHONE
PHONE
RJ11
Jack
PHONE
LINE DSL
(Existing Cable)