Pioneer SH-DT510 - Manual (Page 19)

19
MANUAL SCAN
Manual Scan search the channel based on user request frequency and
bandwidth.
• On the Installation page, select
MANUAL SCAN and press
"ENTER" button.
• Select channel number. Be sure you
know the channel number and its
RF frequency.
• Check FREQUENCY,
BANDWIDTH and PRIORITY to
ensure that these parameters are
correct, then highlight Start Scan
and press "ENTER" button to start
the scan.
• When the tuner locks onto a channel, the words "Start Scan" will change to
"Get Channel Success" (Ideally it should be "Get Channel Success" but if
difficult to change OSD, leave as it is). You can press RETURN twice to leave the
Installation page and watch the program immediately or continue scanning for
other channels. If you want to know the signal level and SNR (Signal to Noise
ratio) while watching a digital TV channel, navigate to this page.
• If the signal is not locked, "Start Scan" will show "Timeout error". You can try
to scan the signal again, or refer to the Signal Level bar and Quality band to
align the antenna to improve your signal reception. Contact an antenna installer
if you cannot lock onto the signal after trying all of the suggestions in this
manual.
CLEAR ALL DATA
• This option allows you to reset the
tuner to its factory settings, losing
all channels and setup changes you
have made. Select CLEAR ALL
DATA to reset the tuner.
WARNING:
Do not choose this option if you do
not understand the functioning of the
tuner. No viewing channels will remain
afterwards. Setup procedures and
scanning will have to be performed
again after taking this step.