5 poe switch rear panel, 2 installing poe switch, 1 desktop installation – Planet Technology FGSW-2620PVS User Manual
Page 10
2.1.5 PoE Switch Rear Panel
The rear panel of the Switch indicates an AC inlet power socket, which accepts input power from 100 to 240VAC, 50-60Hz.
Figure 2-3 shows Rear panel of the Switch.
Figure 2-3 Rear Panels of FGSW-2402PVS / FGSW-2620PVS / FGSW-2612PVS
Power Notice:
1.
The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the
time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data loss
or network downtime.
2.
In some area, installing a surge suppression device may also help to protect your Switch from being dam-aged by
unregulated surge or current to the Switch or the power adapter.
2.2 Installing PoE Switch
This part describes how to install your Web Smart Ethernet Switch and make connections to the Switch. Please read the
following topics and perform the procedures in the order being presented.
To install your Switch on a desktop or shelf, simply complete the following steps.
2.2.1 Desktop Installation
To install a Switch on a desktop or shelf, simply complete the following steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the Switch.
Step2: Place the Switch on a desktop or shelf near an AC power source.
Step3: Keep enough ventilation space between the Switch and the surrounding objects
Note:
When choosing a location, please keep in mind the environmental restrictions discussed in Chapter 1, Section 4,
Specification.
Step4: Connect your Switch to network devices
A.
Connect one end of a standard network cable to the 10/100 RJ-45 ports on the front of the Switch.
B.
Connect the other end of the cable to the network devices such as printer servers, workstations or routers…etc.
Note:
Connection to the Switch requires UTP Category 5 network cabling with RJ-45 tips. For more information, please
see the Cabling Specification in Appendix A.
Step5: Supply power to the Switch.
A.
Connect one end of the power cable to the Switch