Paradyne 6371 - Manual (Page 128)

C. Traps and MIBs
C-18 March 2002 6300-A2-GB20-00
Interface Configuration MIB
The Paradyne proprietary Interface Configuration group, pdn_inet.mib, is
supported. Refer to
Table C-11, Interface Configuration Group Objects Table , for
additional details.
ARP MIB
The objects from the proxy ARP MIB group, pdn_Arp.mib, are:
T pdnNetToMediaClearAllArp (pdnNetToMediaConfig 2) – Setting this object to
clear removes all entries from the ARP table and is equivalent to the
command:
arp purge
T pdnNetToMediaProxyArpTable
NAT MIB
The objects in the Network Address Translation MIB group, pdn_NAT.mib, are
fully supported. The groups are:
T Network Address Translation Group – Facilitates the creation and
configuration of NAT entries. The DSL router accepts any valid public IP
address (up to 256 addresses) and subnet mask for basic NAT operation.
T NAPT Mapping Group – Facilitates the creation and configuration of NAPT
mappings. The DSL router accepts any single, public IP address for NAPT
operation. The subnet mask 255.255.255.255 is used when the NAPT IP
address configuration information is viewed.
T NAT Basic Mapping Group – Facilitates the creation and configuration of
Basic NAT mappings.
Table C-11. Interface Configuration Group Objects Table
Object Description Setting/Contents
pdnInetIpAddress
(pdnInetIpAddressTableEntry 1)
Identifies the interface IP address. T Interface IP address or
T 0.0.0.0 – Unnumbered interface
pdnInetIpSubnetMask
(pdnInetIpAddressTableEntry 2)
Identifies the interface subnet
mask. The subnet mask.
pdnInetIpAddressType
(pdnInetIpAddressTableEntry 3)
Use to view the address type for
an interface. Supported as
read-only. T primary
T secondary
pdnInetIpRowStatus
(pdnInetIpAddressTableEntry 4)
Use to add/delete/modify rows in
this table. When used to add a new interface entry,
the objects specifying the table entry must
be included in the same Set PDU.