Pioneer DV-585K-s - Manual (Page 12)

Connecting up 02
12
En
Watching progressive scan video
from the component video outputs
This player can output progressive scan video
from the component video output. Compared
to interlace video, progressive scan video
effectively doubles the scanning rate of the
picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive
scan TV, see
Video Output settings on page 34.
When the player is set to output progressive
scan video, the
PRGSVE indicator lights in the
front panel display.
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the player to progressive, you will not be
able to see any picture at all. In this case,
switch everything off and reconnect using
the supplied video cable (see
Easy
connections on page 10), then switch back
to Interlace (see below).
Switching the video output to interlace
using the front panel controls
Switch the player to standby then, using the
front panel controls, press
STANDBY/ON
while pressing to switch the player back to
Interlace .
Compatibility of this player with
progressive-scan and high-definition TVs
This player is compatible with progressive
video Macro Vision System Copy Guard.
Consumers should note that not all high-
definition television sets are fully compatible
with this product and may cause artifacts to be
displayed in the picture. In case of 525/625
progressive scan picture problems, it is
recommended that the user switch the
connection to the ‘standard definition’ output
(Interlace). If there are questions regarding our
TV set compatibility with this model, please
contact our customer service center.
This player is compatible with the following
Pioneer displays and monitors:
Plasma display
PDP-502MX, PDP-503HDG, PDP-433HDG,
PDP-5040HD, PDP-4340HD, PDP-504HDG,
PDP-434HDG, PDP-435HDG, PDP-505HDG
Projection monitor receiver
SD-532HD5, SD-533HD5
STANDBY/ON
DV585K_KARAOKE.book Page 12 Thursday, April 7, 2005 9:32 PM