Panasonic PT-LW80NTE - Manual (Page 41)

E
NGLISH - 41
Settings
SECURITY menu
J Entering the SECURITY menu
Every time when you apply to the SECURITY
menu, you will be asked to perform the password
operation.
Q Before you change the password to
your original
Perform to input the following factory default
password operation.
1. Perform F H G I F H G I.
2. Press the ENTER button.
Q After you change the password
You can change to your original password in the
PASSWORD CHANGE menu.
1. Perform the original password operation.
2. Press the ENTER button.
You can activate the security system and the password
operation will be asked to perform when projecting mode
started. Unless you perform the correct password
operation, all of the button controls will be disabled
except the POWER button.
OFF Deactive
ON Active
You can change the password operation to your original.
1. Press a series of button operation up to 8 as a
password by using F G I and H buttons.
2. Press the ENTER button.
3. Press the exact same series of button operation
you entered in the NEW password box for
confirmation.
If a series of button operation is incorrect, you will be
asked to perform again.
4. Press the ENTER button.
You can set your original text, such as company name or
URL information, to display regularly at the bottom of the
projected image while projecting.
OFF Deactive
ON Active
NOTE:
• The factory default password is valid until you change
the password in PASSWORD CHANGE menu.
• The entered password operations will appear as
asterisks in the box.
• When the projector is initialised, it will be reset to the
factory default password operation.
MENU RETURN
Remote control Control panel
See “Navigating through the MENU” on page 29.
See “Main menu and Sub-menu” on page 30.
PICTURE
POSITION
INPUT PASSWORD
PASSWORD CHANGE
TEXT DISPLAY
TEXT CHANGE
PASSWORD
LANGUAGE
OPTION
SECURITY
WIRELESS
OFF
OFF
ENTER
RETURN
INPUT PASSWORD
NOTE:
• When you activated the security system, make sure to
change the password to your original for safety.
• The security system is deactivated by default and when
initialised.
• When the projector is initialised, it will be reset to the
factory default password operation.
PASSWORD CHANGE
NOTE:
• The entered password operations will appear as
asterisks in the box.
• Change your password regularly.
• Do not use too simple password to guess.
TEXT DISPLAY