PLUS Vision V-1100Z - Manual (Page 68)

E-68
5.
Install the new lamp cartridge
(1) Slowly push in the lamp cartridge with the
socket facing forward. (Align the lamp cartridge
screw with the screw hole of the projector.)
(2) Turn the 2 screws of the lamp cartridge clock-
wise to tighten.
6.
Install the lamp cover
(1) First insert the front edge of the lamp cover into
the groove, then close the lamp cover.
(2) Turn the screw of the lamp cover clockwise to
tighten.
Replacing the Lamp Cartridge
7.
Reset the lamp timer to zero.
Plug in the power cable and switch on the power before resetting.
Select [Info.]
→ [Lamp Timer Reset] and then reset the hours indication.
NOTE: The projector will no longer start when the lamp timer exceeds 1,100 hours. As a result, it will not be
possible to reset the lamp timer through timer operations.
Should this situation arise, set to the standby condition and press the SOURCE button and the ASPECT button of
the main unit at the same time for at least 5 seconds.
When reset, the STATUS indicator will go off.
Please obtain a replacement lamp from your dealer. When ordering, please specify a V-1100Z replacement lamp
type V-120 (order code 28-060).