Planet Technology SKD-200 - Manual (Page 16)

16
( with smart country
code )
00886 (Taiwan’s country code is 886)
2. Pick up the handset and press the button.
3. Dial area code + telephone number
4. To end the call, either press the button or replace the handset on the
charger.
Make a PSTN Call
1. Pick up the handset and press the button.
2. Dial a PSTN phone number.
3. To end the call, either press the button or replace the handset on the
charger.
Receiving a Call
1. When a call is coming, press button to answer it.
2. To end the call, either press the button or replace the handset on the
charger.
Using Speaker Phone 1. To turn the speakerphone on, press
and hold the button until the icon
appears on the display.
2. To turn the speakerphone off, press and hold the button until the icon
disappears on the display.
Muting the
Microphone
1. To mute the microphone, press the button while icon appears.
2. To turn to the normal mode, press button once more.
Note: In the mute mode, the icon will appear on the display.
Adjusting Voice
Volume
1. Press or button to adjust the volume level.
Note: During a call, you can adjust the earpiece volume from level 1 to 9.
Register Handset 1. Turn on USB or Adapter power (the base will open to register for 1 minutes)
2. Press button to go to HS register, press INT button to enter.
3. Select the desired DECT base (Base1 for example). Press INT key,
DCT-100 will display Searching…. on the LCD screen
4. Wait till a machine hardware ID shows up, ex: 002F5-11708H, then press
INT
5. When machine prompts for PIN number, inert PIN number 1590 then press
INT, then DCT-100 will start to register to base and showing Searching….
6. Once the registration is completed, the DCT-100 will show HS x, Base y on
the screen. (x is the registered handset number and y is the registered
DECT base.)
Note: Registration is available
Clear Registration 1. Power off the DCT-100 handset.
2. Press the INT button and R power on button together, and DO NOT release
the buttons till the LCD displays "F->clear Subs"
3. Press the button to clear the handset base settings.
4. Wait till " Not Sub " displayed; it is now not registering to any DECT base.
Transfer Call 1. During handset 1 (HS1) conversation, press the INT button and enter the