Porter-Cable 7414 User Manual
Page 4
4
unauthorized parts or failure to follow Maintenance Instructions may create a
risk of electric shock or injury.
SPECIFIC SAFETY RULES AND SYMBOLS
1.
Always use proper guard with grinding wheel. A guard protects
operator from broken wheel fragments.
2.
Accessories must be rated for at least the speed recommended on
the tool warning label. Wheels and other accessories running over rated
speed can fly apart and cause injury.
3.
Hold tool by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its own
cord. Contact with a “live” wire will also make exposed metal parts of the
tool “live” and shock the operator.
4.
Always use an approved guard with those accessories that require a
guard (see ACCESSORIES Section of this manual).
5.
Use proper safety equipment. Wear safety goggles to protect your
eyes and wear a protective mask to minimize breathing in the fine dust
created while sanding. NOTE: Some wood contains preservatives which can
be toxic. Take extra care to prevent inhalation and skin contact when
working with these materials.
6.
Sanding of lead-based paint is not recommended. Lead-based paint
should only be removed by a professional.
7.
Do not install woodcarving blade on this grinder.
8.
WARNING: There are certain applications for which this tool was
designed. Porter-Cable strongly recommends that this tool NOT be modified
and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you
have written Porter-Cable and we have advised you.
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
SYMBOL
DEFINITION
V
.......................... volts
A
.......................... amperes
Hz
.......................... hertz
W
.......................... watts
kW
.......................... kilowatts
µF
.......................... microfarads
l
.......................... liters
kg
.......................... kilograms
N/cm
2
.......................... newtons per square centimeter
Pa
.......................... pascals
h
.......................... hours
min
.......................... minutes
s
.......................... seconds
.......................... alternating current
3
.......................... three-phase alternating current
283800 - 07-31-00.QXD 9/23/02 1:34 PM Page 4