PYLE Audio PLR7N - Manual (Page 18)

16
1. Connect a Back View Camera video output to AV1,2 or 3 video Input terminals on
the rear of the unit.
* When the VCD changer is connected to AV3 Video input, The back view camera can
be connected only to AV1 or AV2 video input.
2. Press the MODE button to select radio mode.
3. Press the MENU button to select following picture.
NOTE
CAMERA IN
Connect orange color connection wire named “REVERSE GEAR” to a switched power
output terminal of the R (reverse) gear.
See page 26: BASIC CONNECTIONS.
SETTING THE CAMERA IN
4. Press the SEARCH UP/DOWN button to select CAMERA IN.
5. Press the VOLUME
button to select AV1,2 or 3 mode that Back View
Camera is connected. Each time you press this button, AV Input changes as
AV1 -> AV2 -> AV3 -> OFF
Set the rear gear on any mode. The monitor shows the back view camera picture.
WATCHING THE BACK VIEW PICTURE
RADIO SUB MENU
WIRING CONNECTION
If AV input connected to the Back view Camera is selected with the MODE
button, the monitor does not show the back view camera picture.
The Monitor shows only the WARNING picture.