Powermatic 2000 - Manual (Page 10)

10
Assembly
Mounting Extension Wings
Referring to Figure 1:
1. Mount a cast iron extension wing (A) to the
right or left side of the table (B) using three
each 3/8-16x1 hex head screws (C), 3/8 lock
washers (D) and 3/8 flat washers (E). Have an
assistant hold the extension wing up to the
table while inserting the screws and washers.
Finger-tighten only.
Note: If an assistant is not available, hold the
wing in vertical position up to the saw table,
insert the middle screw and lock washer finger
tight, then pivot the wing to level position. Insert
the other two screws and washers finger tight.
2. Mount the remaining extension wing to the
other side of the table in the same manner.
3. Make sure that the front edge of the extension
wings are flush with the front edge of saw table
(Figure 2).
4. Level the extension wing with the saw table
across its entire width (Figure 3) using a
straight edge and hammer with block of wood
(or rubber hammer).
As each area of the wing becomes flush with
the table, tighten the screw under that area.
Continue until all three screws are fully
tightened.
5. Repeat for the other extension wing.
Figure 1
Figure 2
Figure 3