Panasonic SC-HT940 - Manual (Page 10)

R
Q
T
8582
10
Simple
Se
tu
p
Conserving power
The main unit consumes a small amount of power, even when it is turned off (For U.S.A. and Canada: approx. 0.4 W or for other areas: approx.
0.9 W). To save power when the unit is not to be used for a long time, unplug it from the household AC outlet.
You will need to reset some memory items after plugging in the unit.
[Note]
The included AC power supply cord is for use with this unit only. Do not use it with other equipment. Also, do not use cords for other equipment with
this unit.
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the display ( ➜ page 11), avoiding obstacles, at a maximum
range of 7 m (23 feet) directly in front of the unit.
STEP
5
Radio and AC cord connections
FM ANT
75 75
AC IN AC IN
AM
ANT
EXT
LOOP
LOOP ANT GND
Adhesive tape
To household AC outlet (AC 120 V, 60 Hz)
[For\areas\except\U.S.A.\and\Canada]
≥ If the power plug does not fit your AC
outlet
Use the power plug adaptor (included).
If it still does not fit, contact an electrical
parts distributor for assistance.
AC power
supply cord
Main unit
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other wires
and cables.
Click!
AM loop antenna FM indoor antenna AC power supply cord
\U.S.A.\and\Canada] Power plug adaptor
\Areas\except\U.S.A.\and\Canada]
FM indoor antenna
Affix this end of the
antenna where
reception is best.
≥ Connect the AC power supply cord after all other connections are complete.
≥ Using an outdoor antenna (optional) (
➜ page 27).
The illustration shows SC-HT740 for U.S.A. and Canada.
\Others]
Re-tighten the terminal
screw.
Loosen the terminal screw with
a Phillips-head screwdriver.
White Red
Black
While pushing, insert the wire fully.
STEP
6
Preparing the remote control
R6/LR6, AA
Remote control Batteries
Insert so the poles ( i and j) match those in the remote control.
≥ Do not use rechargeable
type batteries.
Press in and lift up.
Replace the cover.
Ra
dio and A
C
cor
d
co
nnec
tion
s
/
Pr
e
parin
g
the
rem
ote
c
ontr
ol
8582En_p03-13.fm Page 10 Monday, February 13, 2006 5:41 AM