Panasonic SC-HT940 - Manual (Page 5)

RQ
T
8
5
8
2
5
Simple
Se
tu
p
[HT940]
1
Attach the speaker to the stand.
Place the polyfoam underneath the speaker for stability while
attaching the speaker to the stand.
1 Feed the speaker cable (the shorter part) into the bottom
of the speaker and through the slot at the rear.
2 While pulling the speaker cable up through the slot, slide
the speaker stand into the bottom of the speaker.
3 Thread the cable through the middle hole of the slider and
fasten the slider with the two screws.
2
Attach the stand to the base.
1 Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do not
crease), pass the folded portion through the hole, and then pull
the rest of the cable through the base.
2 Insert the stand into the base while gently pulling on the
end of the cable.
3
Secure the stand to the base.
4
Adjust the speaker height.
1 Loosen the screws until
the speaker can slide up
and down the stand.
2 Raise the speaker to the
desired height, and then
re-tighten the screws .
5
Connect the speaker cable.
6
Secure the speaker cable to the base.
∫ Preventing the speakers from falling
≥ You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
≥ Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
2 Front speakers 2 Bases 2 Stands (with cable) 6 Screws 2 Sliders
Cable
Speaker
Stand
Polyfoam
Screws
Tighten securely.
Slider
Cable
Base
Rounded side
Large hole
Cable
Cable
Screw
Tighten securely.
Phillips-head
screwdriver
_
: White
`
: Blue
Insert the wire fully.
Push!
Press the speaker cable into the groove.
Push excess cable back through the
slider holder.
Cable
Slide the cable
into the groove.
String (not included)
Thread from the wall to the speaker and tie tightly.
Rear of the speaker
Wall
Approx.
150 mm
(5
29 /
32
z)
Screw eye
(not included)
e.g. [HT740] [HT743]
A
s
sem
b
ling
the
fr
ont
spe
ake
rs
The speaker height
can be adjusted.
Min: 110 cm (43 1 / 4
z)
Max: 135 cm (53 5 / 32
z)
HT740 & 940En.book Page 5 Friday, February 24, 2006 7:47 PM