Paxar Monarch PPT 2700 - Manual (Page 4)

4 Operating Instructions
When you have linked the modules, they can talk with each other up to 20
feet apart.
NOTE: When you are not using the printer, terminal, and RF link device,
be sure to turn them off.
S c a n n i n g B a r C o d e s
To scan a bar code:
1. Point the scanner at a slight angle approximately 4 – 8 inches from
the bar code symbol.
2. Pull the trigger until you hear a beep, which indicates a complete
scan. If you let go of the trigger before the beep, the scan stops
immediately.
CAUTION: Do Not stare into the beam.
If the bar code does not scan:
♦ Change the angle of the scanner slightly and try again.
♦ Clean the scanner window.
♦ Move the scanner 4 – 8 inches away from the bar code. Adjust this
distance as needed to find the correct distance.
♦ Try scanning another bar code that you have scanned successfully. If
that scan is successful, the scanning problem is with the bar code.
♦ Move to a more dimly lit area.
♦ Be sure there are no voids in the bar code symbol.