Panasonic KX-MB2060 - Manual (Page 112)

Display Cause & Solution
“REMOVE PAPER IN INPUT
TRAY #2” R The recording paper is installed in the manual input tray when trying to
receive faxes or print reports. Remove the recording paper from manual
input tray.
“REPLACE DRUM CHANGE
SUPPLIES” R The drum cartridge’s service life is finished. Replace the drum cartridge and
the toner cartridge immediately.
“RX MEMORY FULL” R The memory is full of received documents due to a lack of recording paper
or a recording paper jam. Load paper (page 16) or remove the jammed
paper (page 126).
R If the PC fax (feature #442 on page 86) is set to “ALWAYS”,
– check the connection between the computer and the unit.
– check that the computer is turned ON.
R If the fax preview mode (feature #448 on page 66) is set to “ON”,
– view, print or save the received fax documents using the web browser
on the computer connected via the LAN, and then erase the
unnecessary documents (page 66).
– turn the setting to “OFF”. The fax documents stored in memory will be
printed automatically.
“SCANNER POSITION
ERROR” R There is something wrong with the scanner position. Turn the power switch
OFF, then ON. If the problem cannot be solved, contact our service
personnel.
“SERIAL ERROR” R There is something wrong with the unit. Contact our service personnel.
“SUBSCRIBE TO CALLER ID” R You must subscribe to use Caller ID service. Contact your service provider/
telephone company for service availability. Once you receive caller
information, this message will not be displayed.
“TONER EMPTY”
“CHANGE SUPPLIES” R The toner is empty. Replace the toner cartridge immediately.
“TONER LOW”
“CHANGE SUPPLIES” R The toner is reaching the end of its life. You will need to replace the toner
cartridge soon.
“TOP COVER OPEN” R The top cover is open. Close it.
“TRANSMIT ERROR” R A transmission error occurred. Try again.
14.2.2 Cordless handset (KX-MB2060 optional)
Display Cause & Solution
“Base no power”
or
“No link. Re-connect
base AC adaptor.”
R The cordless handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Turn the base unit’s power switch OFF to reset the unit. Turn the power
switch ON and try again.
R The cordless handset’s registration may have been canceled. Re-register
the cordless handset (feature #130 on page 104).
“Busy” R The called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The cordless handset you are using is too far from the base unit. Move closer
and try again.
“Call phone company for
your access #” R You have not stored the voice mail access number. Store the number
(page 101).
“Error!!” R Recording was too short. Try again.
“Invalid” R There is no cordless handset registered to the base unit matching the
cordless handset number you entered.
R The cordless handset is not registered to the base unit. Register the cordless
handset (feature #130 on page 104).
112 For assistance, please visit http://www.panasonic.com/help
14. Help