Pioneer AVH-P6400 - Manual (Page 63)

En 63
English
Espa
ñ
ol
Deutsch
F
ran
ç
ais
Italiano
Nederlands
13
Section
Other Functions
• When using a DVD player unit connected with
an RCA cable, if you do not select
M-DVD , there
will be no picture even if you switch sources.
• When using a DVD player unit connected with
an AV-BUS cable, do not select
M-DVD . If you
do, there will be no picture.
• If you select
BACK UP CAMERA , press
∞ to
move to BACK UP POLARITY , or use
2 or 3 to
select BATTERY and GND .
BATTERY : When the gear shift is moved to the
REVERSE (R) position, and the polarity of the
connected lead wire is positive.
GND : When the gear shift is moved to the
REVERSE (R) position, and the polarity of the
connected lead wire (refer to page 30) is nega-
tive.
• This product features a function that automat-
ically switches to the video input into the video
or back camera jack when a back-up camera is
installed on your car. If this is the case, when
the gear shift is in the REVERSE (R) position,
the video automatically switches to video or
back camera. (The default setting is
BATTERY .
For more details, consult with your dealer.)
Notes
• If you do not operate the function within about
30 seconds, the display is automatically
returned to the playback display.
• If you select BACKUP CAMERA , switching to
the correct video setting may not occur.
Confirm that directly after changing the set-
ting, it changes to VIDEO when the gear shift
is moved to REVERSE from another position.
• If you select BACKUP CAMERA , the display
changes to VIDEO during normal drivings,
reverse the settings.
Setting the automatic open
mode
To prevent the display from hitting the shift lever
of an automatic vehicle when it is in the “P”
(park) position, or when you do not wish open-
ing/closing of the display to be carried out auto-
matically, you can switch this function ON/OFF.
1 Press
5 or ∞ to select
AUTO FLAP from the
SET UP MENU, and press A.MENU .
AUTO FLAP adjustment indications are dis-
played.
2 Press
2 to select the manual.
Press
2 until the OPEN/CLOSE:MANUAL
setting appears in the display. Each time you
press a manually set monitor’s EJECT, the moni-
tor opens or closes.
3 Press
3 to select the auto.
Press
2 until the OPEN/CLOSE:AUTO setting
appears in the display. With auto setting, the
monitor automatically opens or closes when
power to this unit is switched ON.
Note
• If you do not operate the function within about
30 seconds, the display is automatically
returned to the playback display.