Paxar Monarch 9855 - Manual (Page 10)

6
Die Cut Sensor
Supply
Lever
Nibs
Deflector
Supply Roller
5 .
Adjust the supply holder guides so the sides barely touch the roll. Make sure
the supply roll turns freely.
If you are using fan-fold supplies, place the supply stack behind the printer,
label side facing up.
6 .
Push down on the supply lever to unlock the supply guides.
7 .
Lay the label strip across the supply guide so that a few inches extend past the
front of the printer. Tuck the supply under the nibs and in between the die cut
sensor. Do not feed supply between the supply roller and deflector. For fan-
fold supplies, lay the label strip over the supply holder and across the supply
guide so that a few inches extend past the front of the printer. Tuck the supply
under the nibs and in between the die cut sensor.
8 .
Adjust the supply guides so they
touch the supply.
Push up on the
supply lever to
lock the supply guides
into place.
Supply Holder Guides