Paxar Monarch 9855 - Manual (Page 3)

RFID Regulatory Compliance
This section details the regulatory compliance information specific to the RFID
components in your printer. It may not apply to other RF devices in the printer.
Refer to the documentation provided with those other RF devices for regulatory
information.
Paxar RF products are designed to be compliant with the rules and regulations in
the locations into which they are sold and will be labeled as required. The majority
of Paxar RF devices are type approved and do not require the user to obtain a
license or authorization before using the equipment. Check your local regulations
for more specific information. Any changes or modifications to Paxar equipment
not expressly approved by Paxar could void the user authority to operate the
equipment.
FCC RF Exposure Guidelines
To comply with FCC exposure requirements, antennas that are mounted externally
at remote locations or operating near users at stand-alone desktop of similar
configurations must operate with a minimum separation distance of 20 cm from all
persons.
Declaration of Conformity for RF Exposure:
The radio module has been evaluated under FCC Bulletin OET 65C and found
compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and
15.247 (b) (4) addressing RF Exposure from radio frequency devices.
Radio Frequency Interference Requirements
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference that may cause undesired operations.
CAUTION:
The Part 15 radio device operates on a non-interference basis with
other devices operating at this frequency when using the listed
antenna.
If the equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
♦ Re-orient or relocate the receiving antenna.
♦ Increase the separation between the equipment and receiver.
♦ Connect the equipment into an outlet on a circuit different from that which the
receiver is connected.