Panasonic DMR-ES10 - Manual (Page 9)

RQT8009
9
G
e
tt
ing st
ar
ted
■ Connection to a stereo amplifier ■ To enjoy multi-channel surround sound on
DVD-Video
Use one of the following connections to suit the antenna lead.
•
If your television has both lead and coaxial VHF terminals, use the
lead connection to minimize signal loss.
■ A single twin lead
■ A twin lead and a coaxial cable
■ Two twin leads
Use one of the following connections to suit the antenna terminals
on your television. Refer to the television’s operating instructions.
■ A twin lead and coaxial plug terminal
■ A twin lead terminal
■ Two twin lead terminals
■ Multiple antenna terminals
Connecting an amplifier or system component
AUDIO IN
R L
OPTICAL IN
Connect an amplifier with a built-in decoder
displaying these logo marks using an optical digital
audio cable and change the settings in Digital Audio
Output (
➔ page 33).
•
You cannot use DTS Digital Surround decoders not
suited to DVD.
•
Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
Insert fully, with this
side facing up.
Amplifier's rear panel
Amplifier's rear panel
Audio cable
Optical digital
audio cable
Do not bend sharply
when connecting.
This unit
Red White
Red White
If the antenna connector doesn’t match
Other antenna connections to the unit
To this unit’s RF IN
terminal
from the antenna
(Flat) Twin lead
300
Ω cable
300–75
Ω transformer
To this unit’s RF IN
terminal
from the antenna
(Flat) Twin lead 300 Ω cable
VHF/UHF band mixer
(Round)
75
Ω coaxial cable
To this unit’s RF IN
terminal
from the antenna
(Flat) Twin lead
300
Ω cable
VHF/UHF band mixer
300–75
Ω transformer
Other antenna connections from the unit to the
television
Television
VHF/UHF band separator
75
Ω coaxial cable
VHF
UHF
Television
75–300
Ω transformer VHF or
UHF
75
Ω coaxial cable
Television
VHF/UHF band separator
75
Ω coaxial cable
VHF
UHF
Television
•
Connect to one of the ANT terminals, then change the television’s
setting as necessary.
75
Ω coaxial cable
Split out
ANT 1
ANT 2