PYLE Audio PLCD20CH - Manual (Page 19)

19
Commander
FM Modulator/
Ground Isolator
M3 x 12
• Random play
- When the random button (RANDOM) is pressed, “RANDOM ONE” appears, and
the tracks on the disc now heard are played in a random order. When all the
tracks have been played, they will be played again, this time in a different random
order.
- Press this button for a second, “RANDOM ALL” will be shown on the display.
When “RANDOM ALL” function is activated, all tracks of each CD will be played
in random order until all of them have been played once.
- Press the random button again to release the disc random play function.
Listening to the radio or tape
Press the power off button ( ........ ) to stop the CD play, and listen to the radio or tape.
* Noise is heard and the reception deteriorates when listening to the radio without
stopping CD play first.
To resume CD play, set the radio's FM frequency to 89.1 MHz or 88.7 MHz and
press the play/pause button.
INSTALLATION
Procedure To Mount The CD Changer Commander unit
1. Determine where the commander unit will be located.
2. Be sure that the mounting surface where the commander unit will be located, is
clean and dry.
3. Remove the protective paper from the back of the double sided tape.
4. Apply the commander unit to the desired location.
Installation of the FM Modulator/Ground Isolator
Install the FM Modulator/Ground Isolator to the floor or other surface with the included
tapping screws (M3 x 12).