Troubleshooting, Error messages showing on display of controller – PYLE Audio PLCD20CH User Manual

Page 23

Advertising
background image

www.pyleaudio.com

Symptom Cause

Remedy

No power.

Improper connection.

Check connections.

Magazine cannot Direction in which it is

Insert it in proper direction.

be installed.

inserted is wrong.

CD is not played. Disc has been loaded

Load disc with play side facing

upside down.

up.

Noise is heard

Large scratches on disc or

Compare sound with another

during playback

warped disc.

disc. If sound from second disc

or sound is

is acceptable, first disc is

intermittent.

defective.

Extremely dirty disc.

Clean disc.

Transit screws still in place. Remove screws (x 3) on bottom

of unit and then use.

Built-in anti-vibration

Install board in proper direction.

board is installed in wrong

(Refer to “installation” in

direction.

Operating Instructions.)

TROUBLESHOOTING

An error made in operation or in the connections is sometimes mistaken for a failure
or breakdown. Perform the checks described in the following table before calling in
the servicing engineer.

Cause Remedy

E-01

Mechanism problem.

Press “RESET” button.

Improper magazine

Eject magazine and try again.

installation.

E-07

Improper magazine

Eject magazine and try again.

installation.

Disc has been loaded up

Load disc with label facing up.

side down.

Not original disc.

Try another original disc.

Laser lens in high humidity. Turn on the car and wait

approximately one hour.

Dirty disc

Clean the disc and load the disc
as instruction manual mentioned.

23

Error Messages showing on display of controller:

Advertising