Pantel PAN520 - Manual (Page 17)

17/30
CVBS + Audio L/R input
RCA jack accepts composite video input format.
RCA*2 jacks (color-coded: white and red) to accept Audio L/R input.
3D-COMB filter applied.
Brightness, Contrast, Color, Tint, Sharpness and Color Temperature control,
VGA input + Audio L/R input
15-pin D-SUB jack accepts VGA signal input or color component (480i, 480p,
720p, 1080i input format, also 1080p for 52” and 65” models)
input.
OSD can switch to VGA input mode or color component input mode.
When OSD select VGA signal input, Auto-Sync without cropping, all
resolutions (depends on VESA standard and up to 1280X1024), all vertical
refresh rates (from 56Hz to 75Hz). AutoSync shall function with DMT, GTF,
CV, and CV RB timings. The system shall not be table driven.
The preferred resolution and timing would be 1360x768 / 1920 x 1080 @ 60
Hz. Other resolutions would do scaling to fit the whole video onto the whole
screen or keep the aspect ratio when in PC mode.
PC inputs (both VGA and DVI) should be displayed either 1:1 mode centered
in the screen, scaled to either full height or full width of the screen with aspect
ratio preserved, or scaled to fill the full screen with aspect ratio not preserved.
In all cases there should be no overexpansion of PC Modes.
Brightness, Contrast, Color, Tint, Sharpness and Color Temperature control,
HDMI input
HDMI type-A jack accepts HDMI (480i, 480p, 720p, 1080i input format, also
1080p on 52” and 65” models) input or DVI (PC mode) input. HDMI input
mode will support 480i, 480p, 720p, 1080i modes at least. When in PC mode,
Auto-Sync without cropping, all resolutions (depends on VESA standard and
up to 1280X1024), all vertical refresh rates (from 56Hz to 75Hz).
The preferred resolution and timing would be 1360x768 / 1920 x 1080 @ 60
Hz. Other resolutions would do scaling to fit the whole video onto the whole
screen or keep the aspect ratio when in PC mode.
PC inputs (both VGA and DVI) should be displayed either 1:1 mode centered
in the screen, scaled to either full height or full width of the screen with aspect
ratio preserved, or scaled to fill the full screen with aspect ratio not preserved.
In all cases there should be no overexpansion of PC Modes.
Brightness, Contrast, Color, Tint, Sharpness and Color Temperature control.