Pantel PAN520 - Manual (Page 25)

25/30
‹ Power Switch Press the power button to turn the power ON/OFF
‹ DC IN Connect the DC-in from the supplied AC adaptor here
‹ S-VIDEO IN Connect the S-Video cable here if the input source - DVD, VTR
etc has an S-Video out.
‹ S-VIDEO OUT This is a through signal of the S-Video IN
‹ Audio OUT This is a through signal of the Audio IN
‹ Video OUT This is a through signal of the Composite Video IN
‹ Audio In Connect the Input source Audio in using supplied AV cable
‹ Video In Connect the Input source Video in using supplied AV cable
‹ IR Connector If remote control is required connect the supplied IR cable here.
‹ Pairing SW Pairing setup (see later instructions)
NOTE:
The IR function enables the user to control the DVD (or other video
source) even when the TV and the DVD are not in the same room. The user can
use the DVD’s remote control unit by pointing the remote control at the IR
receiver located at the VW-5RX. The IR signals are conveyed by wireless signal
to the VW-5TX.
Chapter 2 Setup Menus
The following lists a step by step set-up procedure.
Step 1~4 STV-1100TX Transmitter Unit
Step 1 Connect power cord
Connect power cord to AC adaptor.
Attach AC adaptor to DC IN jack on VW-5TX unit.
Step 2
Power On
Press the power button on the rear to turn the power ON.
Step 3 Connect video sources
Connect your Video device (DVD, VAR, PVR, STB or BS) using the supplied
S-Video or AV video cable
Step 4 Video Input
Connect AV cable to video input jack and/or connect S-Video cable to S-Video IN
jack on the VW-5TX unit. If both signals are available the S-Video will be the
priority and used due to its higher quality.
IR Function
If you require use of a remote control connect the included IR cable at the back of
the VW-5TX unit. Then locate the LED head module of the cable in front of the
usual IR receive point of the input source (e.g. DVD player, cable box)