Panasonic ES8109 User Manual

Page 9

Advertising
background image

9

English

1

1

1

Cleaning with the self-cleaning recharger (continued)

1

1 Follow the steps outlined below if the status lamp blinks or glows

during the “Clean/Dry/Charge” course or the “Clean/Dry” course.

Blinks

Glows

Correctly set the
detergent cartridge and
then restart a course.

Remove the shaver from the self-
cleaning recharger and then
check that the [CLEAN] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self-
cleaning recharger is placed
horizontally.

If the status lamp goes
out

Continue a course.

When an abnormality has
been corrected

When no abnormality was
found

Press and hold [SELECT] for
approximately  seconds to
turn off the status lamp and
then restart a course.

It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.

When the status lamp
goes out

When the status lamp glows
again

Continue a course.

Contact an authorized service
center.

Cleaning the shaver without the self-cleaning
recharger

We recommend that you clean
your shaver with the self-cleaning
recharger or the “sonic” vibration
turbo-cleaning mode when the
faucet symbol appears on the
LCD panel.
1. Disconnect the power cord

from the shaver.

. Apply some hand soap and

some water to the outer foil.

3. Press the OFF/ON switch for

more than  seconds to
activate the turbo mode for
“sonic” vibration cleaning.

appears on the LCD

panel.
After about 0 seconds, it
will be automatically turned
off, or you can turn it off by
pressing the OFF/ON switch.

4. Remove the system outer foil

and press the OFF/ON switch
for more than  seconds to
activate the turbo mode for
“sonic” vibration cleaning and
clean it with running water.

5. Wipe off any drops of water

with a dry cloth.

6. Remove the system outer foil

and the foil frame to allow
them to dry completely.

ES8109_USA.indb 9

2007/07/25 13:23:21

Advertising