Polycom KIRK 14117800 - Manual (Page 54)

54 Installing the KIRK Repeater
14117800, Ed.2.6
Note: The external antenna used for the transmitter is to be fixed-mounted on indoor permanent
structures providing a separation distance of at least 20 cm / 8 inches from all persons during normal
operation and must not be co-located or operating in conjunction with any other antenna or
transmitter. The maximum radiated output power is 1W e.i.r.p. For more information and technical
support, please refer to www.polycom.com.
Recording the Installation Information
After completing the installation of the repeaters, record the location of each repeater.
5.2 Checking Indicators
Verify that the repeater LED indicator is continuously on, indicating that the repeater is
functional.
5.3 Powering the KIRK Repeater
5.3.1 Power Options
The power supply for the repeater is 9VDC, 300mA.
5.4 Programming a KIRK Repeater with the KIRK Programming Kit
This section provides information about:
•
Content of the KIRK Programming Kit Repeater on page 54
• Set up of the Hardware for Repeater Programming on page 55
• Programming the KIRK Repeater with the ServiceTool on page 55
5.4.1 Content of the KIRK Programming Kit Repeater
The Programming Kit Repeater (Part no. 02319508) consists of:
• splitter
• serial cable