Panasonic CQ-R223W - Manual (Page 8)

Radio
CD Changer Control
(When a CD changer is connected)
Tape
(When a tape is inserted)
E
N
G
L
I
S
H
4
CQ-R223W
15
E
N
G
L
I
S
H
3
Radio
CQ-R223W
14
M O D E
CQ-R223W DOLBY B NR
D IS P
TRACK
TUNE
REMOTE
LO UD
MONO MUTE
DISC SCAN REPEAT RANDOM
APM
B A N D
PW
R
VOL / P US H SE L
1 MTL NR 2 5 B•S 6 3 TPS REP 4
B A N D
MONO
M O D E
TRACK
TUNE
Radio mode
Press [MODE] to switch the operation mode as follows:
q
Band
Press [BAND] to change the band.
Manual Tuning
[[ TUNE]: Higher frequency.
[] TUNE]: Lower frequency.
Seek Tuning
Press and hold for more than 0.5 second ...
[[ TUNE]: Higher frequency.
[] TUNE]: Lower frequency.
Tuning will automatically stop when the signals
of the next broadcast station are received.
e
Mono Selection
Press [MONO] for monaural reception in case a lot of
interference is present in an FM stereo signal or to
improve the listening quality of weak FM broadcasts.
Press [MONO] again to cancel.
r
FM stereo indicator
M O D E
CQ-R223W DOLBY B NR
D IS P
TRACK
TUNE
REMOTE
LO UD
MONO MUTE
DISC SCAN REPEAT RANDOM
APM
B A N D
PW
R
VOL / P US H SE L
1 MTL NR 2 5 B•S 6 3 TPS REP 4
Preset buttons from [1] to [6]
Display Change
Press [DISP] (display) to switch to the clock display.
Preset Station Setting
Up to 6 stations can be saved in each of the FM1, FM2,
FM3 and AM preset station memories.
Note: Existing saved stations are overwritten with new
stations after following this procedure.
Band
Press [BAND] to select a desired band.
(
➡ page 14)
q
Auto Preset Memory (APM)
Press and hold [BAND] (APM: auto preset memory) for more
than 2 seconds.
• The 6 stations with good reception will be automatically
saved in the memory under preset buttons [1] - [6].
• Once set, the preset stations are sequentially scanned for 5
seconds each.
Manual Preset Memory
ᕡ Use manual or seek tuning to find a station. ( ➡ page 14)
ᕢ Press and hold one of the preset buttons from [1] to [6]
until the display blinks once.
w
Caution: To ensure safety, never attempt to preset stations
while you are driving.
Preset Station Calling
Press the corresponding preset button from [1]
to [6] to tune in a preset station.
Frequency Clock display
MONO indicator
blinks once
B A N D
1 MTL NR 2 5 B•S 6 3 TPS REP 4 D IS P
preset number
w