Panasonic CQ-CB8901U - Manual (Page 26)

51
Installation
CQ-CB8901U 50
Installation
CQ-CB8901U
1
3
2
ACC
BATTERY 15A
FRONT SP
REAR SP
Power Lead (ACC or IGN) To ACC power, +12 V DC.
Ground Lead To a clean, bare metallic part of the car chassis.
Battery Lead To the car battery, continuous +12 V DC.
Fuse (15 A) Refer fuse replacement to your nearest authorized Panasonic
Servicenter. Do not try fuse replacement by yourself.
(Red)
(Black)
(Yellow)
(Blue w/white stripe)
(Blue)
External Amplifier Control Power Lead To an external amplifier.
(Max. 100 mA)
(R) (Red)
(L) (White)
Pre-out Cord (Rear)
Pre-out Cord (Front)
AUX1-IN
CH/AUX2-IN
S ･W-OUT
PRE-OUT REAR
PRE-OUT FRONT
Antenna
AUX Input Connector
CD Changer/AUX/XM receiver Input Connector
The RCA cord of a CD changer/AUX/XM receiver
should be connected.
Subwoofer Output Connector
The RCA cord of a external power amplifer should be connected.
Motor Antenna Relay Control Lead To Motor Antenna. (Max. 100 mA)
(This lead is not intended for use with a switch actuated power antenna)
Front Left + (White)
Front Left – (White w/black stripe)
Rear Right + (Violet)
Rear Right – (Violet w/black stripe)
Front Right + (Gray)
Front Right – (Gray w/black stripe)
Rear Left + (Green)
Rear Left – (Green w/black stripe)
Speaker lead
(R) (Red)
(L) (White)
(R) (Red)
(L) (White)
(R) (Red)
(L) (White)
Not used (Brown w/white stripe)
(Red)
(White)
Cautions
¡ This unit is designed for use in a car having a 12 V negative ground battery system.
¡ To prevent damage to the unit, be sure to follow the connection diagram below.
¡ Strip about 5 mm of the lead ends for connection.
¡ Do not insert the power connector into the unit until the wiring is completed.
¡ Be sure to insulate any exposed wires to prevent short circuiting with the car chassis. Bundle all
cables, and prevent cable terminals from touching any metal parts.
¡ Remember, if your car has drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
Electrical Connections