Panasonic CQ-CB8901U - Manual (Page 27)

53
Installation
Installation
CQ-CB8901U 52
Installation
CQ-CB8901U
System Upgrade Example: Connecting with an XM Receiver
CQ-CB8901U
CQ-CB8901U
Ground Lead
Battery Lead
DIN Connector
DIN Cord
XMD1000
(Option)
(L) (White)
(R) (Red)
RCA Cord (Option)
CH/AUX2-IN
Power Lead
(L) (White)
(R) (Red)
XMDPAN100*
(Option)
*Please understand that Panasonic
is not liable for modification of
specifications, shape, name, and
the like of the optional XM
receiver and digital adapter
without prior notice because they
are not manufactured by
Panasonic.
Battery Lead
DIN Cord
CH/AUX2-IN
CX-DP880
(Option)
Ground Lead
(R) (Red)
RCA Cord
(L) (White)
Extension Cord
(DIN/BATT/RCA/GND)
(Supplied for an optional CD Changer)
System Upgrade Example: Connecting with a CD changer
● A CD changer, an XM receiver cannot be connected at the same time.
¡ For connection to a CD changer (CX-DP880) or DVD changer (CX-DH801U), refer to the operating
instructions of corresponding device.
¡ For details, consult the shop where you purchased this product.
Connection with a CD Changer/XM Receiver
Caution: Please follow the instructions given below. Failure to do so will cause damage to the unit
and speakers.
¡ Use ungrounded speaker only.
¡ The maximum speaker input should be 50 W or more. (If used with
the optional power amplifier, the speaker input should be higher than
the maximum amplifier output.)
¡ The speaker impedance should be 4 - 8 Ω.
¡ This unit uses the BTCL circuit, so each speaker should be connected
separately using parallel vinyl insulated cords.
¡ The speaker cords and the power amplifier unit should be kept away
(about 30 cm apart) from the antenna and antenna extension cord.
¡ Do not connect more than one
speaker to one set of speaker
leads. (except for connecting to a
tweeter)
Speaker Connections