Panasonic KX-TG1063 - Manual (Page 24)

Programming
24 For assistance, please visit http://www.panasonic.com/help
*1 If “System setting” column is checked, you do not need to program the same item using another unit.
*2 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up the
handset to answer a call, turn off this feature.
*3 The base unit and handset can display the Internet address where you can download the operating
instructions or get further information for this product, using your computer.
*4 Turn this feature off if you prefer not to hear key tones while you are dialing or pressing any keys,
including confirmation tones and error tones.
*5 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a tone (base unit: tone 1
to 6/handset: tone 1 to 5). If you select a melody, you cannot distinguish lines by their ringers.
*6 If you select one of the melody ringer tones, the ringer tone continues to play for several seconds even
if the caller has already hung up. You may either hear a dial tone or no one on the line when you
answer the call.
*7 The preset tones and melodies in this product are used with permission of © 2007 Copyrights Vision
Inc.
*8 When the ringer volume is turned off, ~ is displayed and the base unit and/or handset do not ring for
outside calls.
However even when the ringer volume is set to off:
– the base unit rings at the low level for intercom calls (page 38).
– the handset rings at the lowest level for alarm (page 25) and intercom calls (page 38), and rings at
the highest level for paging (page 38).
*9 The flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if
necessary. The setting should stay at “700ms” unless pressing {FLASH} fails to pick up the waiting
call.
*10Generally, the line mode setting should not be adjusted. If “New Voice Mail” is not displayed, even
when the message indication service is available (page 37), you need to change the line mode to “A”.
*11This feature allows the unit to automatically adjust the date and time setting when caller information
is received. To use this feature, set the date and time first.
Y VM tone detect
(VM: Voice mail) { 3}{3}{2} <On>
Off r 37
Y Voice prompt
(Change language) { 1}{1}{2} <English>
Español r 12
Operating
unit Feature Feature
code Setting System
setting
*1
Page
TG106x(e).book Page 24 Friday, January 16, 2009 10:45 AM