Panasonic SC-HT60 - Manual (Page 15)

15
RQTV0110
INPUT SELECTOR
TUNE MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
TUNED MONO SLEEP PCM ST
kHz
MHz
DIGITAL INPUT
DIGITAL DTS
PL 2CH MIX
SFC
M
C.FOCUS
Main unit
[% DIGITAL, DTS, % PL ΙΙ]
Lights to indicate the source's input
signal and decoding format used.
%
DIGITAL: Dolby Digital sources
DTS: DTS sources
%
PL ΙΙ: Dolby Pro LogicΙΙ
decoder is being used
Display
[SFC, 2CH MIX]
SFC: Appears when
you are using an SFC
mode
2CH MIX: Appears
when you are
listening to a multi-
channel source with
headphones
[INPUT SELECTOR, <, >]
For selecting input.
[VOLUME]
Volume control.
[ ]
Headphone jack
Plug type: 3.5 mm stereo
Sound does not come from the speakers if
you connect headphones.
Avoid listening for prolonged periods of time
to prevent hearing damage. •
•
[PCM, C. FOCUS]
PCM: Lights when the PCMFIX
mode is set
C.FOCUS: Appears when you
are using Center Focus
[DIGITAL INPUT]
Lights when input is
digital.
Control Guide/Making a recording/The RESET function
POWER INPUT SELECTOR TUNE MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
INPUT SELECTOR
Making a recording
You can record to a unit connected to DVR/DVD-P OUT.
You can record any analog source except DVR/DVD-P IN.
1. Press [INPUT SELECTOR < or >] to select the
source to be recorded.
2. Begin recording.
Follow your recording unit's operating instructions.
3. Start the source to be recorded.
This unit cannot record digital sources. Connect through the
analog terminals and select "ANALOG" input. (➡ page 21)
Note
Manufactured under license from Dolby Laboratories.
“Dolby”, “Pro Logic” and the double-D symbol are trademarks
of Dolby Laboratories.
“DTS” and “DTS Digital Surround” are registered trademarks
of Digital Theater Systems, Inc.
INPUT SELECTOR TUNE MENU
RETURN
SETUP
MUSIC PORT
VOLUME
ENTER
TUNE MENU
RETURN
SETUP ENTER
The RESET function
The operation settings for the unit will be initialized to the
settings made at the time of shipment.
However, any preset radio stations will not be erased.
1. Press and hold [ ―SETUP] to enter the setup
menu.
2. Press [TUNE - or +] to select "RESET" ➡ [ENTER].
3. Press [TUNE - or +] to select "RESET YES"
➡ [ENTER].
To cancel, select "RESET NO".
SC-HT40GN-offset.indb 15 2/27/2006 11:38:19 AM