Powermatic TS29 User Manual
Page 20
Advertising
20
The bearings in the motor are sealed for life and do not
require lubrication.
The spindle bearing should be lubricated every 200
hours of use by using the grease gun (A) supplied.
See Figure 41. Two grease fittings, one of which (B) is
shown, are supplied on the spindle housing for this
purpose. The other grease fitting is directly opposite
fitting (B). Before lubricating, clean grease fittings (B)
thoroughly and then lubricate the spindle bearings with
two pumps of a good quality, non-hardening grease.
FIGURE 41
Advertising