Pioneer VSX1017TXV - Manual (Page 56)

Using other functions 10
56
En
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources, the
display automatically brightens for a few seconds.
• Press RECEIVER then press DIMMER repeatedly to
change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω .
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel TONE button,
press and hold STANDBY/ON for about three
seconds.
The display shows RESET? .
3 Press the front panel ENTER button.
The display shows RESET OK? .
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
ANALOG
ATT
MIDNIGHT/
LOUDNESS
DIMMER
SLEEP SB ch
SR+
D ACCESS
DIALOG E PHASE S.RETRIEVER
CD RECEIVER TUNER iPod
CD-R/TAPE
VSX-1017TXV_KU.book 56 ページ ２００７年４月１２日 木曜日 午前１１時３２分