Panasonic TU-IRD20 - Manual (Page 8)

BEFORE YOU BEGIN
4
Unpacking the Box
The following items come with your DSS ® receiver:
• Receiver (access card inserted) • S-Video Cable
• Remote Control • VCR Controller
• Coaxial (RF) Cable • Audio/Video Cables
• Telephone Line Cord
1 2 3
4 5 6
7 8 9
0 R-TUNE TV/VIDEO
POWER MUTE
V CR 1 VCR 2 AUX
LD
RC VR
CBL TV
DS S
CH
CH
VOL VOL
MENU
SELECT
GUIDE EXIT
FAV RECALL LOGO TUNE
TV/VCR ALT AUD. TV/DSS
REC STOP PAUSE
DIGITAL SATELLITE RECEIVER
Panasonic
REW PLAY FF
Audio/Video Cables Coaxial (RF) Cable
S-Video Cable
Telephone Line Cord
VCR Controller
MENU
SELECT
POWER
RECALL
TV/DSS
Receiver
Remote Control
Press down here and
slide cover back
AA Batteries
Installing Batteries In the
Remote Control
Follow these steps whenever you need to install or change the
batteries in the remote control.
1. Remove the cover of the battery compartment.
2. Place batteries as shown, matching the + and - end of each
battery in each compartment. Use alkaline batteries.
3. Replace the cover.
Precautions on Battery Use
Incorrect installation can cause battery leakage and corrosion that
will damage the remote control.
Observe the Following Precautions
• Batteries must be replaced as a pair.
• Do not combine a used battery with a new one.
• Do not mix battery types (for example, “zink carbon” with
“alkaline”).
• Do not attempt to charge, short-circuit, disassemble, heat or
burn used batteries.
• Battery replacement is necessary when the remote control
reacts sporadically or stops operating the receiver.