Panasonic WV-CLR920A - Manual (Page 36)

-36-
• Whenever the multiplexed vertical drive pulse (VD2)
is supplied to the camera from an external equip-
ment such as a Matrix Switcher, the camera sync
mode is automatically switched to the VD2 mode.
• When the VBS or VS gen-lock mode is to be used
select INT from this menu and supply the gen-lock
input signal to the Gen-lock Input Connector on the
rear panel.
• The VBS gen-lock mode has a submenu for hori-
zontal and subcarrier phase adjustments. When the
cable length of the video output or the gen-lock
input is changed, the horizontal and subcarrier
phase must be re-adjusted.
• The VS gen-lock mode has a submenu for horizon-
tal phase adjustments. When the cable length of
the video output or the gen-lock input is changed,
the horizontal phase must be re-adjusted.
• The line-lock mode has a submenu for line-lock ver-
tical phase adjustment. If the camera installation is
relocated, check the vertical phase adjustment
again since the AC line phase may be different.
6-1. Internal Sync Mode (INT)
1. Move the cursor to SYNC and select INT.
2. Press
I.
Note: Never supply VD2, VBS, or VS to the camera
when you intend to operate the camera in the
internal mode. Otherwise your selection will be
ignored because INT has the lowest priority.
6-2. VBS Gen-lock Mode (EXT(VBS))
1. Move the cursor to SYNC and select INT.
2. Connect the coaxial cable for the blackburst or
composite colour video signal to the gen-lock input
connector.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵
↵
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC EXT(VBS)
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵
↵
↵
↵
↵