Nicd battery pack – PSC PT2000 User Manual
Page 127
NiCd Battery Pack
User’s Guide
117
z
Switch 1
may be in either position.
5.
Lay the plastic ribbon along the bottom of the battery
compartment with the end sticking out of the compartment.
6.
Insert the batteries in the positions indicated by the diagram
inside the compartment.
7.
Replace the battery-compartment cover by sliding it into place.
z
Make sure the plastic ribbon is tucked underneath the cover.
8.
Replace the hand-strap hook into its holder.
NiCd Battery Pack
The battery pack for the PT2000 and TopGun (PSC part #00-862-00)
contains three rechargeable AA NiCd batteries. To install the NiCd
battery pack, complete the following steps:
1.
Detach the elastic hand strap on the back of the portable by
pulling its hook out of its holder near the base (refer to
on
).
2.
Press on the arrow symbol on the battery-compartment cover and
push the cover in the direction indicated by the arrow.
Caution:
Switch 2
must be in the
ALK
position to prevent the unit
from attempting to charge the alkaline batteries. This
could cause them to leak, damage the unit, and void the
product warranty.
PT2000.book Page 117 Thursday, February 26, 2004 9:34 AM