Using palpro – PSC PT2000 User Manual
Page 33
Collecting Data
User’s Guide
23
3.
Use a bar code scanner (the TopGun module or another device
attached to the PT2000), a magnetic stripe reader, or the keypad
to enter data.
z
When scanning a bar code or running a magnetic stripe card
through the reader, the data is entered at the cursor position
in the application.
z
When using the keypad to enter the data, the data is
displayed in the second line of the PT2000 display screen.
z
Press the
<ENTER
> key, to send the data to the PC.
4.
When finished collecting data, press the
<F5>
key
(
<Alpha>+<F1>
) to exit.
Figure 3-8: The PT2000 Wedge Menu
Using PALPRO
PALPRO
combines three Portable Applications Library applications into
a single, convenient program (refer to
). With
PALPRO
installed
on the PSC portable, it is possible to switch from one application to
another without having to install each application.
Selecting a
PALPRO
Application
Complete the following steps to select a
PALPRO
application:
1.
With the
PALPRO Options
menu displayed, press the
<F2>
key.
Figure 3-9: The PALPRO Options Menu
* PT2000 WEDGE *
¤
F5=EXIT
PALPRO OPTIONS
F3=WEDGE
F2=SELECT PROG
F4=PASSWORD
¤
PT2000.book Page 23 Thursday, February 26, 2004 9:34 AM