Peavey IDC 150T II - Manual (Page 5)

5
INSTALLATION INFORMATION: POWER HANDLING AND GROUNDING
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not advisable to
remove the ground pin under any circumstances. If it is necessary to use the equipment without proper grounding
facilities, suitable grounding adapters should be used. Less noise and greatly reduced shock hazard exists when the unit
is operated with the proper grounded receptacles.
ARCHITECTURAL AND ENGINEERING SPECIFICATIONS
The power amplifier shall have one input with provisions for balanced and unbalanced signals via terminal strip. A
600 ohm balanced line output shall be provided, also via terminal strip. The amplifier shall be capable of delivering
150 watts into 4 ohms at the 25 volt line output, and 150 watts into 33 ohms at the 70 volt line output. This unit shall
have the capability of continuously operating if the AC mains are lost, due to its battery backup circuit (the battery must
be provided). This amplifier shall be compatible with Peavey’s MediaMatrix system, providing a jack for easy hook up
and operation. This amplifier must have a signal-to-noise ratio of at least 100 dB below rated output. The unit shall be
called the Peavey Architectural Acoustics Division model IDC™ 150T
II .
LIMITED WARRANTY
Peavey Electronics Corporation warrants to the original purchaser of this new Architectural Acoustics product that it is
free from defects in material and workmanship. If within one (1) year from date of purchase a properly installed
product proves to be defective and Peavey is notified, Peavey will repair or replace it at no charge. (Note: Batteries and
patch cords not covered.) “Original purchaser” means the customer for whom the product is originally installed.
Damage resulting from improper installation, interconnection of a unit or system of another manufacturer, accident or
unreasonable use, neglect or any other cause not arising from defects in material and workmanship is not covered by
this warranty. The warranty is valid only as to products purchased and installed in the United States and Canada.
THIS LIMITED WARRANTY IS IN LIEU OF ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED,
INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
USE. UNDER NO CIRCUMSTANCES WILL PEAVEY BE LIABLE FOR ANY LOST PROFITS, LOST SAVINGS,
INCIDENTAL DAMAGES OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO
USE THE PRODUCT, EVEN IF PEAVEY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
THIS LIMITED WARRANTY IS THE ONLY EXPRESSED WARRANTY ON THIS PRODUCT, AND NO OTHER
STATEMENT, REPRESENTATION, WARRANTY, OR AGREEMENT BY ANY PERSON SHALL BE VALID OR
BINDING UPON PEAVEY.
Peavey’s liability to the original purchaser for damages for any cause whatsoever and regardless of the form of action is
limited to the actual damages up to the greater of Five Hundred Dollars ($500) or an amount equal to the purchase price
of the product that caused the damage or that is the subject of or is directly related to the cause of action. This limitation
of liability will not apply to claims for personal injury or damage to real property or tangible personal property alleg-
edly caused by Peavey’s negligence. For information on service under this warranty, call a Peavey customer service
representative at (601) 483-5376.