PGS S27R - Manual (Page 16)

Install battery with “+” side facing out.
GAS LEAK TEST
AFTER SIDE BURNER KIT IS ATTACHED TO CART, TIGHTEN
ALL CONNECTIONS, FITTINGS AND SCREWS. PLEASE NOTE
THAT DURING TRANSPORT, CONNECTIONS AND SCREWS MAY
BECOME LOOSE CHECK ALL.
BEFORE ATTEMPTING TO LIGHT GRILL, BE
CERTAIN THE GAS VALVE KNOBS ARE IN THE OFF
POSITION. TURN GAS SUPPLY ON CHECK ALL
CONNECTIONS WITH A SOLUTION OF 50%
LIQUID SOAP, 50% WATER. SOLUTION CAN BE
SPRAYED ON WITH A SPRAY BOTTLE OR PAINTED
ON ALL CONNECTIONS WITH A BRUSH. IF
BUBBLES APPEAR THERE IS A LEAK, TURN OFF
GAS, TIGHTEN FITTINGS AND REPEAT THIS
CHECK.
PLEASE NOTE!!! ABOVE PROCEDURE IS IMPERATIVE FOR SAFE
OPERATION ON YOUR GRILL.
IF THE BURNER FAILS TO LIGHT
IMMEDIATELY TURN CONTROLS OFF TO PREVENT GAS BUILD-UP.
WAIT FIVE MINUTES FOR GAS TO CLEAR AND TRY THE ABOVE
PROCEDURE AGAIN. IF THE BURNER DOES NOT LIGHT WITH THE
ELECTRONIC IGNITION, LIGHT THE BURNER WITH A MATCH OR
OTHER HAND HELD IGNITOR. DO NOT TOSS A LIT MATCH
INTO THE UNIT AND TURN THE GAS ON!
IF THE GRILL STILL FAILS TO LIGHT, CHECK THE GAS SUPPLY.
YOU COULD BE OUT OF LP GAS OR THE MAIN GAS SUPPLY FOR
NATURAL GAS MAY HAVE BEEN TURNED OFF.
USE APPROPRIATE COOKWARE WITH FLAT BOTTOM WHEN
USING SIDE BURNER KIT. PYREX TYPE PANS AND OR
SIMILAR CONTAINERS ARE NOT TO BE USED ON THE SIDE
BURNER AS INTENSE HEAT WILL FRACTURE MATERIAL AND
COULD CAUSE HARM OR DAMAGE. ADJUST THE FLAME SO
THAT IT ONLY HEATS THE BOTTOM OF THE POT OR PAN TO
AVOID THE POSSIBLE LIGHTING OF CLOTHING
ADJUST THE FLAME SO THAT IT ONLY HEATS THE BOTTOM OF
THE POT OR PAN TO AVOID THE POSSIBLE LIGHTING OF
CLOTHING.
16