General features, Audio control 1, Audio setup – PhatNoise KDC-MP8029 User Manual
Page 10
10
|
English
General features
Audio Control
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Basic Audio item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4
Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Rear Volume *
1
"Rear Volume" 0 — 35
Subwoofer level*
2,3,4
"Sub-WLevel"
–15 — +15
Bass level*
5
"Bass Level"
–8 — +8
Middle level*
5
"Middle Level" –8 — +8
Treble level*
5
"Treble Level"
–8 — +8
Balance
"Balance"
Left 15 — Right 15
Fader*
4
"Fader"
Rear 15 — Front 15
Exit Audio Control mode
• *
1
You can control this item when "2 ZONE" of <Audio
Setup> (page 10) is set to "ON".
• *
2
You can control this item when <Switching preout>
(page 32) is set to "SWPRE Sub-W". (KDC-MP8029
only)
• *
3
You can control this item when <Subwoofer
Output> (page 12) is set to "SW ON".
• *
4
You can control this item when "2 ZONE" of <Audio
Setup> (page 10) is set to "OFF".
• *
5
These items can be adjusted in details by the
following methods.
• *
5
Source tone memory: The set up value is put in the
memory per source. (Detail Audio item is included)
5
Exit Audio Control mode
Press any button.
Press the button which is not [VOL] knob and
[ATT]/[ANG] button.
Adjust the detail of Audio Control
1 Select the Audio item for adjustment
By referring to the step 1 — 3 above, select the
desired item to be set in detail from the items
marked with *
5
.
2 Enter Detail adjustment mode of Audio
Control
Press the [VOL] knob for at least 1 second.
3 Select the Detail Audio item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that
can be adjusted switch as shown below.
4 Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item
Display
Range
Bass Center Frequency
"Bass FRQ"
40/50/60/70/80/100/
120/150 Hz
Bass Q Factor
"Bass Q Factor" 1.00/1.25/1.50/2.00
Bass Extend
"Bass EXT"
OFF/ON
Middle level
Adjustment Item Display
Range
Middle Center
Frequency
"Middle FRQ"
0.5/1.0/1.5/2.0 kHz
Middle Q Factor
"Middle Q Factor" 1.00/2.00
Treble level
Adjustment Item
Display
Range
Treble Center Frequency "Treble FRQ"
10.0/12.5/15.0/17.5 kHz
5 Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL] and [ATT]/[ANG]
buttons.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4
Setup the Audio item
Turn the [VOL] knob.