PSC Falcon 4400 Series - Manual (Page 14)

Electrical Considerations
8
Falcon ® 4400 Series Powered Vehicle Dock
Electrical System Connections
This section covers electrical connection to +12V, +24V, +36V and +48V sys-
tems.
Connection to +12V
Figure 4 illustrates a typical wiring connection for a +12 volt system. The
input voltage operating range of the dock will allow direct connection to the
battery terminals. However, the use of a 5-Amp fuse is required, and a Noise
Spike/RF filter is highly recommended.
Accessory equipment may also be required depending on your application,
Refer to Table 1 on page 2-7. Read and follow all manufacturer's installation
instructions carefully.
Figure 4. Wiring Diagram for +12V Systems
CAUTION
Proper installation requires that source power connections be made directly to
the vehicle's positive and negative battery terminals. It is important to maintain
electrical isolation when installing the powered vehicle dock and any accessory
equipment, to ensure safe and proper operation. Do not make any electrical
connections directly to the chassis of the forklift.
Noise/Spike Filter
(Recommended)
DC Conditioner/UPS
(Optional)
Delay Timer
(Optional)*
Use crimp connectors
for all wire connections
** White (N/C)
Dock
Power Cord
Red (Pos)
Black (Neg)
Pos
+
Neg
-
5-Amp In-Line Fuse
(Required)
DO NOT connect the white wire.
Either cut it or ensure it is properly
isolated. ** ENSURE that the device being
installed is properly rated for use
on your vehicle *
Fuse each device according to
manufacturer’s recommendation