Pixel Magic Systems MTV5000 - Manual (Page 8)

2
Tour of Magic TV™
15 14
Power On/Off Switch. Turn Magic TV™ on using this switch.
Magic TV™ consumes very little power on Standby. It is therefore
unnecessary to turn Magic TV™ off with this switch during normal
operation.
DC Power In. The included 100-240V AC auto-ranging power
adapter should be attached here. Please see “Safety Information”
before proceeding.
Ventilation holes. It is important that all the ventilation holes in
Magic TV™ are kept clear, in order for hot air to escape.
HDMI. (Connects to a TV, AV receiver or home theatre system.)
HDMI provides a pure digital connection for high definition video
and audio all in one cable.
Composite Video. (Connects to a TV, AV receiver, VCR, DVD
recorder or home theatre system.) Composite is the most basic of
video connections and is Standard Definition only.
S-Video. (Connects to a TV, AV receiver, VCR, DVD recorder or
home theatre system.) S-Video offers a higher quality signal than
Composite for compatible equipment but is Standard Definition only.
Component Video (YPbPr). (Connects to a TV, AV receiver or
home theatre system.) Component provides an excellent quality High
Definition analogue video connection.
Coaxial Digital Audio. (Connects to an AV receiver or home
cinema system.) If you are not using the audio over HDMI, then this
connection will provide multi-channel digital audio to your surround
sound system.
Optical Digital Audio. (Connects to an AV receiver or home
cinema system.) If you are not using the audio over HDMI, then this
connection will provide multi-channel digital audio to your surround
sound system.
Analogue Stereo Audio. (Connects to a TV, VCR or DVD
recorder.) Connect the left/right audio cables (included) for
analogue stereo sound.
USB x2. Magic TV™ can be updated with new software via USB.
See section 8.2.
Ethernet Network. Use this connection to link Magic TV™
to your home network. This may be needed for some of the
Interactive Services.
RS232 Interface. Reserved for factory use.
Loop Out (Antenna Out). Connect the included Aerial/Antenna
extension cable from this output to another device if you wish to
retain analogue TV reception (on your TV for example).
Antenna In. A coaxial RF cable needs to be connected to this
input to allow Magic TV™ to receive the new DTT signals.
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
2.2 Rear Panel
1
2
4
6
5
7
8
9
10
11
12
13
14
15
3
2
Tour of Magic TV™