Pelco ESPRIT ES30C - Manual (Page 19)

C309M-J (9/04) 19
AZIMUTH ZERO
Azimuth is the pan angle from 0
°
to 359
°
. Azimuth zero is the programmed 0
°
point that is normally set to magnetic north. Once
programmed, on-screen pan position (azimuth) and compass readings are based on the set azimuth zero point.
To set azimuth zero:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Az/El/Direction.
5. Press the Iris Open button to enter the Az/El/Direction menu.
6. Position the cursor (>) beside Set Azimuth Zero.
7. Press the Iris Open button. The programming menu for Set Azimuth Zero appears on the monitor.
8. Use the joystick to pan the Esprit unit to the desired azimuth zero (0
°
point) position.
9. Press the Iris Open button to set the azimuth zero position.
<Camera>
<Line Sync>
<Power Up>
<Wiper>
<Limit Stop>
<Other>
Exit
MAIN MENU
Proportional pan On
Park time minutes 0
Scan Speed deg/s 25
Pattern Length 1.5 min
Spd Profile
<Zone Blank>
<Az/El/Direction>
Exit
Other Menu Az/El/Direction
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Zoom
Zoom Line
Disp Duration
Exit